Add this MINI Cooper Blow Off Valve by Forge Motorsport for added power and turbo noise!

This valve is recommended for any vehicle where the boost pressure has been increased by an ECU software upgrade and for unmodified vehicles operating in warmer climates, as a solution to the many failures that have occurred.

The most common complaint on the OEM solenoid valve is a split diaphragm preventing the valve from opening fully, or not at all. This doesn’t always result in a check engine light as the valve can still be blown open by the boost pressure. Forge has seen many valves with this problem .The other problem is that diaphragm retaining ring is made from very thin plastic that goes brittle with heat cycles, and eventually fails. This prevents the diaphragm from sealing with the same problems as mentioned above. This particular failure also results in the valve falling apart upon removal from the turbo, though in extreme cases bits of plastic can enter the turbo and destroy it.

The alternative is a fully engineered solution offering both significantly improved reliability . The valve is piston based, with no diaphragm to fail, and of all aluminum construction, it replaces the original unit with a pressure/vacuum operated piston valve that still also retains the desirable OEM ECU control over valve actuation. The valve has been proved on the VAG scene for many years. The spring is interchangeable for different levels of boost, and the solenoid is plug and play with the wiring harness which is included.

Fits:

• MINI Cooper S Clubman R55 (2008-2010)
• MINI Cooper JCW Clubman R55 (2009-2012)
• MINI Cooper S R56 Hatchback (2007-2010)
• MINI Cooper JCW R56 Hatchback (2009-2012)
• MINI Cooper S R57 Convertible (2009-2010)
• MINI Cooper JCW R57 Convertible (2009-2012)
• MINI Cooper R59 Roadster (2011 - on)
• MINI Cooper R60 Cooper S/ Countryman/ All4

CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov